Guide to Floor SandingAfter removing the carpet (if there is any), hardboard, tacks and gripper strip use a nail punch and hammer and punch down all nails at least 2mm under the wood surface. Also countersink any screw heads. By doing the above you will make your abrasives last a lot longer! Then you should start with an abrasive, either our cloth floor sanding belts or sanding discs would be ideal. Depending on the state of the wood decides where you start with the grits. (for really rough wood you should be looking to start between 24 & 36 grit). You should start by sanding the floor until it is flat and true. If the wood is uneven the abrasives wont sand properly. Make sure you sand thoroughly and don’t skimp on the abrasives! When finishing wooden floors it is vital that you are thorough. For the main part of floor sanding the machines commonly used are belt sanders, edge sanders, corner sanders & trio sanders - we can supply all these machines and consumables to suit. The main grits used in floor sanding are 24,36,40,60,80 & 120. 1st Stage – Level floor with a 24 or 36 grit (belt + edger)
** Please bear in mind that this is a broad guide to Floor Sanding. For a more in-depth, specific guide we will happily look at your application and make exact recommendations based on your requirements. |
